1. Before starting the stainless steel gear pump, check whether the corner bolts, pipelines and flanges are loose, whether the valve switch is flexible, check whether the electrical wiring is loose, whether the on-site and remote transmission instruments, control valves are qualified, and repair the on-site wiring problems to ensure Normal use of SS gear pump;
2. Turn the SS gear oil pump coupling 2 to 3 times by hand, it should feel relaxed and light and average, and pay attention to distinguish whether there is friction noise and foreign objects such as rolling noise in the pump. If there is any, you should try to exclude it and remove the coupling The protective cover of the device is installed;
3. Check the oil level of the oil storage chamber of the stainless steel gear oil pump, add oil if necessary, and ensure that the motor has been added with a suitable amount of lubricating grease;
4. Open the valve of the suction line of the stainless steel gear oil pumps to make the liquid fill the pump, open the vent valve, roll the coupling, remove the gas in the pump, and check that the valve on the process line should be in the pump-on position;
5. Open the SS gear oil pumps cycle cooling water inlet and outlet valve, close the communication valve, and observe the pressure gauge on the cycle cooling water pipeline;
6. Close the outlet valve of the stainless steel gear pump and start the motor;
7. Check the stainless steel gear pump for any abnormalities. If oil leakage, vibration, sharp noise, excessive temperature rise, etc. are found, the pump should be stopped immediately.