+86-317-8227664
Annie@saikenpumps.com
The speed of the SS gear pump mainly depends on the process fluid. If the oil is transferred, the pump can rotate at a very high speed, but when the fluid is a high-viscosity polymer melt, this limitation will be large reduce. It is very important to push the high-viscosity fluid into the two-tooth space on the side of the suction port. If this space is not filled up, the pump cannot discharge the accurate flow rate.
The stainless steel gear pump can be changed by changing the speed of the pump and the pump structure, so as to achieve the purpose of adjusting the flow rate. But for the SS gear oil pumps that has been working, the method of changing the structure of the stainless steel gear oil pump is not convenient, and due to the change of the structure of the SS gear oil pump, the versatility of the pump is reduced, although it is economical and convenient to adjust the flow at certain times. It is also rarely used.
The easiest way to change the flow of a gear oil pumps is to use the opening of the pump outlet valve to control it. The essence is to change the position of the pipeline characteristic curve to change the working point of the pump.
+8617731766260/15094407290
+86-317-8227664
+8615094407290