• google+
  • facebook
  • twitter
  • linkedin
  • youtube
language

+86-317-8227664+86-317-8227664

Annie@saikenpumps.comAnnie@saikenpumps.com
Correct use of thermal insulation asphalt pump

2020-07-19

  1. The operating direction of the heat preservation asphalt pump must be determined before starting up, and it must not be reversed.
  2. It is strictly forbidden to run the thermal insulation asphalt pump without any medium to avoid damage to the stator.
  3. The G-type single screw pump that is newly installed or stopped for several days cannot be started immediately. You should inject a proper amount of oil into the thermal insulation asphalt pump body, and then use a pipe clamp for a few revolutions before starting.
  4. After transporting high-viscosity or particle-containing and corrosive media, use water or solvent to flush to prevent blockage, so as to avoid difficulty in starting next time.
  5. Line up for effusion in winter to prevent freezing and cracking.
  6. Lubricating oil should be added to the bearing box regularly during the use of the stainless steel thermal insulation asphalt pump. If there is leakage at the shaft end, the oil seal should be treated or replaced in time.
  7. If an abnormal situation occurs during operation, stop immediately to check the cause and eliminate the fault.

Asphalt Gear Pump
   

the professional team to service !

    If you have questions or suggestions,please leave us a message,we will reply you as soon as we can!