• google+
  • facebook
  • twitter
  • linkedin
  • youtube
language

+86-317-8227664+86-317-8227664

Annie@saikenpumps.comAnnie@saikenpumps.com
Maintenance of KCB gear oil pump

2020-07-13

The 4 common methods of maintaining the KCB gear oil pump are as follows:
 
    1. Note that the KCB gear oil pump should be kept in a dry, clean and free of corrosive gas.
 
    2. The KCB gear oil pump is frequently inspected and maintained, and the power cord must be checked: whether the internal wiring, plugs, and switches are in good condition, whether the insulation resistance is normal, the brush tailstock is loose, the commutator is in good contact with the brush, and the armature is expanded around the stage Whether the stator winding is properly interrupted, whether the bearings and rotating parts are damaged, etc.
 
    3. KCB gear oil pumps that have not been used for a long time or used in a humid environment must be measured with a 500-volt megohmmeter for the insulation resistance of the winding before use. If the insulation resistance between the winding and the motor housing is less than 7 megohms, the winding must be dried.
 
    4. Save each part and exchange the same parts. When disassembling and inspecting the KCB gear oil pump, you should save each part. Pay special attention to the explosion-proof surface of the flame-proof parts. In case of damage, new and identical parts must be replaced. Substitute materials that are lower than the performance of the raw materials or parts that do not match the original specifications must not be used. When assembling, all parts should be installed in the original position and cannot be omitted.

KCB 7600 Lube Oil Pump
   

the professional team to service !

    If you have questions or suggestions,please leave us a message,we will reply you as soon as we can!